Build a power ping-pong ball launcher using two wheels attached to spinning toy motors. When power is turned on, change the trajectory angle to see how far they go. Challenge students to see who can hit a target with the best accuracy. Requires 'AA' batteries. Comes with: - [3] Multiblocks, Green
- [4] Clip Connectors, Blue
- [1] Connector Block, 0.63" (16 mm) Square
- [1] Snap-Off Rod, Gray
- [6] Slit Rods, Blue, 3.93" (100 mm) Long
- [6] Slit Rods, Blue, 7.87" (200 mm) Long
- [4] Tubes, Blue, 7.87" (200 mm) Long
- [4] Gears, 1.57" (40 mm) Dia.
- [2] Rubber Bands, 1.77" (45 mm) L
- [2] Rubber Bands, 2.36" (60 mm) L
- [1] Ping-Pong Ball
- [2] Electric Motors, 4.5 V DC
- [1] Battery Holder with On/Off Switch, 3 V DC
- [1] Bolt, 0.11" (3 mm) Dia. x 0.59" (15 mm) Long
- [2] Converters, 0.07" (2 mm) to 0.16" (4 mm) Dia.
- [1] Piece of Wire, Yellow, 19.68" (500 mm) L
- [1] Bag
- [1] Piece of Sand Paper
Bulk Pack of 10 Kits.
NOTES: Kre8® Kits can be assembled in regular classrooms. Snips or the Kre8® Cutter
is required to cut card and light blue tubes.
Individual kit also available, see below.
|
